you’re really easy to print if you lose one the quality is great and I work as a real one. Definitely recommend to print a couple extra if you’re really into this kind of stuff.

really easily printed all one plate really nice quality and it works as expected

it looks really nice and it doesn’t work for me because I can’t open the lid. Just be careful when you’re down this to make sure that your research is too cold. Otherwise it can be really really hard to open.

this rented really nicely in the details you have really well on the print even with a 0.4 mm nozzle definitely recommend printing and great design. Thank you

It’s really easy to print and it looks really nice as well

it’s a really nice mall the only thing it takes a lot to fill it and there are other planters that take a lot less filament, but it is really nice design

really nice model and if it’s everything really nicely

really nice design a print with a really high-quality even 0.4 mm nozzle it’s pretty sturdy and it holds you out really nicely. Just make sure you don’t press down too hard always it I could get dented.

really cute and if you print it with one colour you can just colour a sharpie. It also has the folding legs at work magnificently and it’s very easy to print.

very nice and it works great with everyone filament definitely recommend it. You can also increase the infill to make it bit stronger.

It looks really nice and it also is really high-quality with really minimal layer lines. I printed on them and they look absolutely great. it’s also really easy to print and very time efficient

very nice print, it’s easy to use and looks nice, no issues at all

prints really easily without and issues. it looks really nice and feels good to hold! a really nice decoration to my house! definitely recommend it! thanks for the model!

very easy to print and it works great, it also uses a very small amount of filament! thanks for the design, it also proves to fit a lot of moka pots and I really do recommend it!

Very nice print, easy to install and mod, only downside is the material cost which is over 150 grams, but if you aren’t going to be using it really roughly you can definitely turn the infill down a fair bit.

Really nice design, it looks great and prints easily with a low amount of material!

Really nice print and doesn’t take a ton of material and also doesn’t produce a lot of waste, but make sure that you are gentle when pulling the head up otherwise it can sometimes snap off. Other than that it’s a great model! 😁

printed really well and has a nice seamless design, it hold everything I need and rarely needs to be cleaned to not show dust.