user_409186668

liamrichards25

Couldn't find fragile stencils anywhere that someone had already made, So I made my own, and 3D printed them to spray onto a flight case I wanted to mark up. Didnt take me long to make so thought I would upload them here! if you find them usefull please post your make!

This Way Up Stencil

stencils

Manufacturing Wizard

Transform your workspace with our Modular Pegboard System! This versatile setup lets you customize and organize your tools and supplies like never before. Lightweight yet sturdy, it’s perfect for any garage, workshop, or studio. With easy installation and a range of accessories, you’ll have everything at your fingertips. Say goodbye to clutter and hello to productivity with this must-have organizational tool!

Modular Pegboard System

garage 

jadamsowers

This is a simple adapter to give your Shure SM57 (or one of its clones) a right-angle bend. It's great for miking snares, where the hi-hat normally gets in the way, and might be useful for miking amps and the like, depending on your mic stand and any other mics you are using on your cabs.To install, unscrew your mic and desolder the leads. Print out the model (use supports) and use a heat gun to soften the ends. Screw the ends into the halves of the mic, one at a time, and let the soft plastic create threads from the mic's metal threads. Unscrew the adapter and run the leads through and re-solder. I put electrical tape over the coupling locations just in case my ‘threads’ decide to escape. Shure themselves say not to do this because it will interfere with the acoustical chamber of the mic and may color the sound. I didn't do a lot of testing but swapping a SM57 with a $20 Behringer clone didn't change the sound in an appreciable way in the mix. Also note that I haven't actually tested this with a SM57– I am fine experimenting with the Behringer clone for the moment, but the bodies look close enough that this should fit. If not, please leave a comment. Disclaimer: Any of the mods performed are your own risk and will most likely void any warranty from the manufacturer. That said, hope this turns out well for you.

stencils

garage

microphones