came out great, even in cheap PETG (using my filament settings). great addition to my bike locker at the office so my dress shoes can stack up without dirtying each other. Definitely appreciate the quick print, but might recommend addictions walls or adjusted infill to stiffen it up a bit as it does sag under the shoes weight.

came out great in PETG. just waiting on the wipers before installing!

thanks for sharing. just used in my Airbnb!

great profile and model. supports pull off quite well and the two parts fit together snug enough I haven’t even bothered with any glue. printed with the supplied model using PETG and overriding with my filament settings

had some issues first go but I think that’s on me after swapping out TPU. second run printed almost perfect aside from connector tab. Nests perfectly on my store bought pyramids too! came out great in BL PETG HF using my (default) filament settings as well.

printed perfect, even decided to test it in BL TPU for AMS no problems

just printed a single, came out great. only comment to the design is it would be nice to have an option to only print the mixer/spreader without the cup as there’s always enough recycling around to use as the mix surface/cup

profile was great. worked perfect even with TPU for AMS with using my (default) filament presets.

took a bit of time but came out great. Happy to fill this gap in my soldering setup