didn’t print well in translucent PETG

print quality is great but access to the charging port isn’t there. I recommend that the creator add one. I don’t think it would be hard to do (although I don’t know how).

printed great, but I use an inner sleeve and the little “nipple” doesn’t stick up far enough to secure the sleeve and stop it from moving. a minor improvement needed - that’s all.

pretty handy

Sooooooo good. I printed in petg and tolerances were tight on the one side… which seems to be a good thing b/c once on it is near impossible to get off (only the one side)

well done

much stronger than it looks… very good spool… lots of space to label

Really nice work, however, the mounting clips keep breaking.

not sure why the flight just can’t be printed attached to the arrow… seems more complicated than it should be, but an excellent print.

it printed great, but once assembled, spools “bottomed out”. once the creator explained that I should turn the little tabs holding the rollers in place (you’ll understand when you look at it) upside down to create more clearance between the spool and the surface that the spool roller is sitting on, everything works tickity boo. great design I personally suggest printing the rollers with fuzzy skin to help the grip between the spool and the rollers. I’ve done it for a few prints of other different spool rollers and it has worked like a charm. you could even print it entirely with 100% fill to give it more weight/stability so it doesn’t move around (re-spooling, etc.). I just finished doing it myself but don’t know how much of a difference it makes yet. the “box” helps stop a spool from jumping forward and out of the spool roller. you can also fasten it down. this is the best “heavy duty” spool roller that I’ve seen and plan on making it my default. BRAVO, JAD

This printed wonderfully, however, it was too big for what I need, and I ultimately ended up printing the smaller one in the end anyway.

printed great but it kept “slipping” until I secured the bolt from spinning using an additional piece of hardware. good work.

haven’t used it but it printed great

was too small to fit over top of the cardboard wheel.

didn’t quite fit

great work but doesn’t tighten enough to hold the spool anything more than very loosely. I’m sure it will work a charm… for somebody else. edit: it turns out that it was the spool and not the print. well designed

I have to be very careful when placing the print plate on the print bed to make sure that the print player isn’t too far back and hitting the nub scrub. other than that this is a really good project. .

printed great, however I have only found one item so far that uses this connector.

the whole AMS riser v2 and its accessories are excellent.

just don’t print it in petg. after printing and despite my best efforts I could not get the petg print to move at the hinge. it was fused. I printed it next in pla and while it was a bit difficult to “break” the hinge so it would close, after a bit of work it performs really well. box is excellent. only giving 4 stars because of how difficult it was to initially close. after getting it to move once it was great.