Printed great. it's going to work real well. Thank you. Boosted

with a little TPU fine tuning it came out great, excited to be accepted in the build program. Thank you

Had a real problem with one filament. couldn't get it to stop stringing. It's poops didn't even look normal (only in 3D printing that isn't a weird statement) finally had to mes with retraction and Z Hop. That did it for me. Thanks

Thank you, thank you, thank you... printed perfect in PETG. Supports were a little tough to remove, but came off very clean. You saved my Son & I, remember when you were a kid and you said, Hey Mom, I have a project at school tomorrow.? Well my son needed a fruit stand for a project. In my day we would have broke out the construction paper , serial boxes , toilet paper rolls , etc. A bit of searching, slicing, printing and wake up to a beautiful fruit stand. Thank you again.... Boosted.

Everything worked perfectly. Thank you

Tell me you love a print without telling me.

Love it. PETG

Fabulous, Used PETG as a support interface and that made removing the supports very easy. I used glue on the end caps for the main gears and handle, make sure you don't use to much...lol... As an Electrical Contractor I HAD to print this. If on a single-pole switch you want the handle to work "properly" (up is on) just remove and replace the switch upside down. (only should be done with power off and by a QUALIFIED individual) My son loves this.

Fabulous, used glitter metallic PLA Blue and matte black. Used PETG as a support interface and that made removing the supports very easy. I used glue on the end caps for the main gears and handle, make sure you don't use to much...lol... As an Electrical Contractor I HAD to print this. If on a single-pole switch you want the handle to work "properly" (up is on) just remove and replace the switch upside down. (only should be done with power off and by a QUALIFIED individual)

Printed great in PETG

Printed great. All ready for the storm. lol

detail is great. support wasn't to hard. need a sharp knife to clean it up. Clamp is going to close up the gap real nice.

Upsized a tad, fits my 11 yo. Printed great. Printing a second. Making it as big as my P2S can handle... literally edge to edge. My daughter is getting the first. She wants it painted PINK!!!! lol

This has been the most fun print I've done in a while. My children will be well liked, not just because they are fabulous individuals, but because they will be spreading joy in their classrooms 😁 Printed on P2S & A1. The A1 had trouble with the bottom slope of the handle, but still acceptable.

Absolutely love these...

Printed very well. Had a little banding. Had to tweak purge. only used supports on critical parts. HANDS. head doesn't need it. When I printed and plate full on my A1 all went well.

printed great, thank you

Printed fabulous in transparent PETG. Very tight, so PLA may break. photos aren't the best because I had to take a picture from my wife's phone and text them to me. I might try TPU. I didn't use supports. BOOSTED....

Absolutely love them. Thank you 😊.