user_3889362486

articulé

JamesThePrinter

These Easter eggs are larger than normal. Actually, they are about the size on an emu egg! I would suggest that you choose 1-3 eggs and display them together. Adding extra eggs printed at varying scales can also look very nice. I have successfully tested them down to 25% scale with the exception of the Lattice Egg. The lattice is a retraction nightmare at smaller sizes. They should scale upwards without issue as well, but beware - they are pretty large already!&nbsp;Check out my other holiday models <a target="_blank" href="https://makerworld.com/en/u/1360890085/collections/23941" rel="nofollow noopener">here</a>.&nbsp;Print SettingsBecause of the size, these eggs take a while to print. I found that I could speed up that process by limiting infill to critical areas only. Most of the examples above were printed at 0.2mm layer heights.&nbsp;<a target="_blank" href="https://www.buymeacoffee.com/JamesThePrinter" rel="nofollow noopener">Buy Me A Coffee</a>&nbsp;The following filaments were used in the pictures above:<ul><li>MatterHackers Quantum Blue Raspberry PLA</li><li>MatterHackers Quantum Green Raspberry PLA</li><li>MatterHackers Quantum Blue Yellow PLA</li><li>MatterHackers Quantum Blue Green PLA</li><li>MatterHackers Quantum Silver Gold PLA</li><li>MatterHackers Quantum Pink Purple PLA</li></ul>

articulé

deco