"H" Series Print Stand If anyone is looking for an excellent printer stand for the H2S, H2D or H2C printer, I discovered one that's sturdy, cheap and gives room for the AMS to sit on the side even. I spent weeks searching and refused to spend hundreds of dollars upwards of over $600 to hold a single printer. Then I by chance ran across this unit. (NOT A PAID AD here. Just a regular consumer) https://www.amazon.com/dp/B0F5VW3WB9?ref=ppx_yo2ov_dt_b_fed_asin_title I now have 2 with a 3rd on it's way to hold my 2 printers and the other as a post processing workbench. Eventually there will be a Multiboard printed for the wall to hold and organize all my tools etc. If your concerned about how these typical metal/allen screw frames are, I understand; however, this one works as I've printed a lot since I got this. TIPS: - If your concerned about the screws shaking loose, use the Blue Loctite on the screws when assembling. I did! - Put the power driver or drill down for this and don't over-torque the screws! This isn't plate metal. Theres enough cross bracing to support and snug with a 15 degree extra twist is fine.