Printed great but when I added the TPU gasket the box hinges immediately split when attempting to close the lid.

I printed this for my grandson as he is currently using crutches due to a soccer related hip injury. He liked it so much that he printed a second one for the other crutch.

The rating is relative to the print quality which was perfect however, other than a soda bottle cap, it doesn’t fit any jar lid in my home. It’s either way too big or way too small. It is shown being used on a mayonnaise jar but it doesn’t even come close to fitting the lid on my jar of Hellmann’s. I should have taken a minute to check the measurements prior to printing so I guess that’s on me. It would be of benefit if the sizes were stated in the description.

The print came out perfect but I found that it might be a good idea to somehow indicate which end is the cap because it’s hard to tell one end from the other when it is mounted inside a reel.