Search models, users, collections, and posts
Bio
Random person in their 30's who got a 3D printer for Christmas and is now finding out that custom solutions to problems is really the most fun way!
Achievements
MakerWorld Guardian
Active more than 20 days out of last 30 days UTC time
Pioneer Maker
Print successful 125 different models and 932 hours
Needed a wall mount that was easy to see and didn't require screws for my new switch, so I made one! :) (TP-Link LiteWave LS105G)
TP-Link LiteWave LS105G Clip-on mount
0
1
Share
0
0
0
Finally got around to replacing my random pieces of metal to mount the Traxxas Maxx light kit onto my E-Revo 2.0, and man, I should've done this sooner!
Mounts for Traxxas Maxx Light Kit for E-Revo 2.0
3
9
Share
0
0
0
It's winter here, and the birds knew from a few years back to check a specific location where there used to be a window-mount bird feeder... Unfortunately that broke, and it's been a while since we've had one... So, since 3d printing solves a lot of problems, I whipped up a corner-mountable bird feeder for them. Hope they appreciate it, and you, too!
Corner-mount Bird Feeder - sloped roof, drainage.
1
4
Share
0
0
0
Profile works as described. I would advise against using it though - it leaves a very roughly printed chainsword. Drop the layer height to .16mm imo, and wait the extra time. It's worth it.
Share
0
0
0
Recently had my better half really get into the South Korean drama "Hotel del Luna" (or "Guest house of the moon"), and she wanted a way to wear the symbol - what better way than to combine with a hairstick that she wears every day anyway!
Hotel del Luna style Hair stick
6
8
Share
0
0
0
Not sure if print profile is at fault - or tolerances, or what. The model fits together great after you sand all the pins and the axle in the center.
Share
0
0
0
Heavy banding where the inner walls connect to the outer walls. Otherwise awesome!
Share
0
0
0
Absolutely perfect for their use case! The lid screws in nicely. Ended up printing 10 in one go. Prints great with Bambu PLA Basic.
The A1 underestimated the print by an entire hour though, so be aware this one seems to trip it up a little.
Share
0
0
0
Peinted with Bambulabs Silk PLA, got an unexpected finish on the top which isn’t so smooth. However this printed fine, articulates well and had good bed adhesion due to its huge surface area. Very fun to play with, and will probably end up printing another one in another colour too!
Share
0
0
0
No more data