I wanted a lower mic stand for my Tonor microphone so I designed these. The thread is 5/8-27 with 0.1mm inset so they screw in smoothly to a standard mic. Use my settings or print with 0.2mm first layer and 0.1 other layers so the threads come out clean. PETG recommended but PLA might be strong enough. My profile is solid because weight adds stability but you can try 20% or maybe even 10% fill

I've struggled with the lack of hard drive mounts on modern cases, and finally I've designed my own cage!

I wanted better looking fan grills so I started designing my own futuristic ones! I'll post more grills, spacers, ducts, etc in the near future.

I made this practical design to keep my Anker C200 powerbank cool in the car. So far so good, and it looks much nicer than my previous method, rubber bands holding the fan in place.

I've been fascinated by car wheel designs since I was a boy and have wanted to design and 3D print RC car wheels for years, and now I'm finally doing it!