good design and printed well in Rapid PETG

great little addition to workshop and good way to use up end of spool filament

loved the model but didn't print too well in Rapod PETG with 0.6 nozzle. The supports under the left arm were a mess and the underside of arm was spaghetti. Could have been filament moisture given insane humidity in this Australian summer but it had been dried and stored in vacuum bag with silica gel. It works as a pen holder and looks fine from above...

good design

Good design, easy print in Rapid PETG, and the stand actually works.

Printed well in Rapid PETG with 0.6mm nozzle. The 22mm hole for the pin is possibly too deep for 18mm benchtops. As the photo shows, the shoulder lifts 4mm when fully tightened. The clamp is secure despite the 4mm gap but would be a stronger hold if the shoulder was flush with benchtop.

Excellent design. Fits my Jaycar adjustable temp soldering iron perfectly and its skookum too,

Great frame clamps. Thanks Matt

handy storage box. Rapid PETG on an A1.

Great print. Handy storage for the Veritas jig and other sharpening bits and bobs.

Sweet little paring guide. Hand cut and pared mitres will be better than ever.

Great print. Rapid PETG on an A1.

printed well

fun print and addictive fidget toy

holds my hand turned mallet very well. good and easy print

Excellent print. Elegoo Rapid PETG on the A1 with BL PETG-HF settings. They fit UKJ Parf system MFT holes perfectly. The inner m6 thread takes a steel nut which makes removal with a magnet simple. Keep screws and small parts from disappearing down dog holes and dust getting inside your bench.

Printed well in Rapid PETG - now to check fitment

Printed well in Rapid PETG on Bambu Labs PETG HF settings. As others have said it can be hard to assemble but it does come together. It is not the strongest of clamps but in tighter dog holes and square boards it holds firm. Will be good for layout or general work holding but not for sawing or planing with hand tools.

Great for hand planing on my mft-style bench. Printed in PETG and its has survived being whacked several times by my hand planes.

printed well in PETG