a nice looking well engineered piece in pla.

does a great job. Don’t forget to buy an assortment of hex cap screws for all your other projects! (You’ll need more than you think if you start printing regularly)

nice print. Should have printed the BIGGEST one instead of the one the same size as the chute exit.

Prints easily. Works as advertised. Only weirdness is that the paper coming out from the roll is always twisted up - have to untwist to get a flat surface onto which to blow your nose. (But still a good print!)

makes elegoo spools roll like Bambu spools - excellent!

great design. Have had a cluttered cupboard for years - this solved the clutter problem!

Cute bookmarks.

This is fantastic. What else needs to be said? Best scraper ever - especially given that the blades are REPLACEABLE! Nice design!

amazing that it just worked out of the printer. No assembly required. Latches are just a bit loose. To resolve I put a thin piece of rubber tape on the inside lip of the latches.

works as advertised!

A very nice print and keeps you from putting things on top of the vent. Was a bit fiddly to get together but once assembled works fine. Also was not clear what the purpose of the spacers was until I tried to install the unit - keeps the glass top away from the front edge so the small lip on the print can fit inside and the print won’t slide around. Thank for the design!

Almost a perfect fit. Had to reduce width of parts that go into the AMS (as printed on H2D too tight to fully seat. Sanded down side using belt sander - now it’s perfect!)

excellent fit and finish for standard 60mm grommet hole. Nice print!

what a great tool. thank you!