user_3397514986

Sairae

Introducing the second model in my Q-tip shooter series… The Q-Tip Crossbow! Simply pull back the latch until it clicks onto the trigger, load a one-sided Q-tip or toothpick, pull back the trigger, and watch it fly! &nbsp;Notes: This model will vary depending on filament. I used Bambu PLA basic which tends to be pretty stiff, so other types of PLA, especially cheap brands, may not yield as good of a result. Keep in mind that brittle/wet filament will be more subject to cracking than newer filament. With other models in this series, people have had good results with PETG, but I have not personally tested it. Make sure to let the model completely cool before using, or else the springs will deform and not be as effective. &nbsp;Check out the original model: <a target="_blank" href="https://makerworld.com/en/models/412624#profileId-314579" rel="nofollow noopener">https://makerworld.com/en/models/412624#profileId-314579</a>

Q-Tip Crossbow

FUTRE

Chas Seelow

Drink and phone holder. Has towel hook so you can DJ your music and keep your phone dry. All compartments have tapered bottoms with drain holes. Modeled to fit “Yeti Style” cup, but any steel cup will most likely fit. Phone slots are generous to hold large phones with case. 2.300&#34; diameter hole to clamp over the liner.

FUTRE

pool

Gridfinity