These printed out on a P2S perfectly, they operate just fine. I have had a hard time attaching them to anything. Bought the stickiest double sided tape I could find. Nothing really sticks well to the PLA I used. A detachable mounting foot for these would be nice. A mounting foot with Screw holes would be perfect.

Printed well on a P2S, when fully loaded with batteries, Neither side feeds very well from the bottom without some poking to dislodge the batt at the top of the feed ramp.

Some of the sliding fits needed a bit of work to get a good fit, I used some stainless rods for the hinges, work much better than using filament.

good design, printed well, solves a TPU issue for me