This was an awesome print! It looks so realistic!

Thanks, these work great to replace the manufacturer covers that often go missing.

Thanks for this simple, elegant design. The colour band in the middle makes it look very professional. I appreciate the two sizes. I sliced a 2mm high piece to see if the 4.5cm would fit my desk, then changed the colour to what I had on the AMS and printed a full size.

Thanks for this. It's a simple design, easy to print and assemble. Works great for the girls' dolls.

This is one of my favourite prints! Smart use of orientation to avoid supports. It works very well and I use it after just about every meal. Thanks for an awesome design.

One of the better Alice bands. I printed a couple of them in one go as the PLA looses it's spring and gets loose over time.

As mentioned by others, the eyes and smile are not in this model. Great near vertical orientation to hide the layering. Unfortunately the supports were very difficult to remove. I printed a larger model at 200% with a 0.6mm nozzle and Extra Draft mode. That was not a good idea as it resulted in a rough surface with very clear layering.

Great print at 150%, used the twin colour, single plate profile with a 0.6mm nozzle and Extra Draft. This leaves clear layer lines but it still looks cool. The head - neck fitting was very tight but at least it won't droop soon.

Awesome retro toy phone for the grandkids. Pin was a bit tight to get in but it won't come out!