printed ok added an extra wall for water proofing ... not sure if it works as not caught any insects yet

onlt printed one but printed nice in pla

printed easy but no easy way to know what each one is for , untill you look at objects even then some you have to think about

good print

very easy print and useful,

fun and easy to put together, one of the grips failed twice so not sure if that is me or an issue on the stl

Printed well, but smaller than expected but that is on me

while this is a good idea and the print does work and does what it says on the tin, i found when i printed both sizes in both PETG and PLA on a smooth plate, the pivot / transition between the 2 pieces to make the swing was so tight / suck, that i ended up braking two of them, 1 large in PETG and 1 small in PLA , once the seperation / release was done it works very well and i am happy with it, its just that initial cracking of the 2 bits that a killer for me.

printed with .4 using ams over all good but very hard to see the sandwiched middle diffrent colour layer

simple and works really well

it printed well in petg - and i found putting together ok, but i had to remove them after casing the filement to cause a motor stall on the ams, i think because the pet tube was pushing the filement to the side

the clip is a little tight usin pla but a nice print

alittle fiddely to get in with out rubbing but not a badprint

just fits and works

good print hinges were stiff to get in but they did go, and needed to glue in clips but was no major issue

simple but usefull

good print but a little to think in my opinion

print on a1 mini went very well , very happy with case, the tools are a bit meh and could be better though

very good print

a little tight and could do with being a little bit thinner but still a good addition