Search models, users, collections, and posts
Bio
Occasional computer gamer, especially Lineage II, KDC2, Wicher 3, fisherman, air rifle shooter, lover of foot tennis, chess, photography, drones, and of course good food and beer... and now also an enthusiast of 3D printing. 2 years as an IT technician and 17 years as a design engineer in a mechanical engineering company. And that's about it .-)
Achievements
MakerWorld Guardian
Active more than 20 days out of last 30 days UTC time
I always cut A4 sheets in half so they’ll fit in an A5 binder, and I always mark the halves or measure them with a tape measure or ruler. Now that I have this template, I don’t have to do that anymore. I don’t understand why the manufacturer didn’t make the tabs for attaching to the laminator a little longer. Otherwise, I wouldn’t need my stop.
GIF
Paper Cutter Stop for A4 to A5 Cuts - Lidl Trimmer
14
40
Share
0
0
0
No problem—printed dozens of hours of TPU 90a and nothing jammed anywhere.
Share
0
0
0
Except for a small part of the upper rear section, the village was printed nicely and without any problems. The rougher surface doesn't matter; it looks like it was done on purpose to make it look snowy.
Share
0
0
0
A very cute, simple two-color print on one board, like two objects, saved a lot of material, and gluing the eyes takes only a few seconds.
Share
0
0
0
The bees are printed at 200% magnification and look great.
Share
0
0
0
No more data