Once again a superb design. Printed without any problems. Thanks for the effort you pput in your lovely creations 👍

Perfect print. Printed with BL basic grey at 40% of original measures. Printtime was 1:01 hour. Thanks for the design.

Perfect print. Printed in BL silk (not yet the silk+) gold. With bigger hands not easy to fit together but went very well. And with some personalalisation I’m sure the granddaughter will like the bling bling handbag 😍. Even if it’s not Dolce or Gucci 😁. Thanks for this fine design.

Perfect print. Thank you for the design.

Perfect print. Thank you for the design.

perfect print. thank you for the design.

perfect print. thank you for the design.

perfect print. thanks for the design.

perfect print. thanks for the design

perfect print. thanks for the design.

Perfect print. Thanks for this fantastic design. I would like to boost your design, but as I did not receive any tokens anymore lately, …. 🤔😥 Already printing the other depths 😁. Is there a possibillity that you would create a version where the bins can be mounted on the snaps that you can see in the left bottom of the photo that I publish in this post? This would result in the possibility to use the bins on more places. The snap I used there is to mount the OG with adhesive to the side of my X1C.

here is the 5 star rating 😉

perfect print. thanks for the design 🙏

I remember this one from years ago, but this version is easier than with writtennpieces of paper 😁. 0% printing problems, 100% fun. thanks for the design

A perfect print. The fit is spot on. Thank you for this design.

Perfect print with BL ABS black. In the picture from left to right: 5-6 mm model downsized to 60% 5-6 mm model downsized to 80% 5-6 mm model at 100% 7-8 mm model at 100% Thank you for the design. This was exactly what I was looking for to use in a homebrew enclosure to put a 12 to 24 volt /10 amps DC-DC convertor while keeping everithing as small as possible.

Perfect print with BL ABS black. In the picture from left to right: 5-6 mm model downsized to 60% 5-6 mm model downsized to 80% 5-6 mm model at 100% 7-8 mm model at 100% Thank you for the design. This was exactly what I was looking for to use in a homebrew enclosure to put a 12 to 24 volt /10 amps DC-DC convertor while keeping everithing as small as possible.

Strange, via website not possible to give the stars while posting. Have to do it afterwards via Bambu handy app. 🤨.

perfect print. tolerances spot on with snug fit of parts. measurement are correct. thank you for this handy tool.