The only cable management solution I've been pretty happy with

absolutely perfect for my use case and printed great!

excellent tool. recommend for anyone doing ironing

Great design. very satisfying feel for a tool

simple print. that works great. best in petg in my experience because they will deform with many uses

My favorite spool container by far

Great model but difficult to get the print to come out perfect and lots of support removal. just very difficult to get the face mask to come out without any sorts of flaws. had to touch it up with my 3D printing pin when it was done

it printed great but something came out just off. I printed the shorter p1s version, but it's still too tall even with my printer sitting on top of a concrete paver

honestly really cool little container. printed great! sometimes I print these just to keep the printer busy

excellent model, profile laid out smartly for printing

absolutely beautiful bookmark. easy print

it printed well. it works! It's a bowl. not much else to say

fantastic! well thought out model. a couple of assembly steps were glossed over in the instructions, but relatively easy to figure out based on the shapes of the pieces.

could be a five-star model with a few tweaks. but the orientation of the main board is nonsense. You have to disassemble half the controller just to plug in the USB cable. flip that sucker around and put a hole in the top of the case. And the press fitting of the joysticks is just not the right solution.

Good model, smooth operation, easy print. My only wish is for a version with a more enclosed handle in case you want to lubricate the mechanisms and keep the mess in, though it works well even without lubrication.

worked and printed great, but it would be nice to have a little more support in the corner to take out some wobble in the stand.

A perfectly proportioned meeple. printed well.

really quality print that creates some neat effects. Use it quickly and without a lot of handling as I did have some pieces delaminate while printing and require an extruder clean out. But that's mostly operator error using strands I could see were imperfect after sitting around rather than just throwing them out.

These are the best cable wraps I've found yet