upscaled considerably with PETG using silent mode for better results. turned out well

looks beautiful, takes a bit of patience and assembly but the end result with the matte filaments are good

absolutely beautiful piece, I used family Labs matte pla and it turned out being good table piece

they look fantastic with the matte colors from Bambulab

I only had threaded rods that worked, but it took a lot of labor to turn it all in together. my only criticism is to possibly model the rods after what is more easy to find at a local hardware store. overall the model is an outstanding piece.

I trimmed off the stone on the bottom and scaled up the size of it. it made a great Halloween decoration after painting it to look more like Stone

the print turned out really well, a wonderful Halloween bucket

small but it works great

had some little bitty parts break off, it is a miracle print that survived.

honestly I expected this could break and fail, and that I would have to do it again and slow down the support speeds by over half taking longer. Printed with a 0.4 nozzle on the lowest layer of height from the preset.

Added ironing on the higher detail settings on a 0.2 nozzle.

used petg translucent, it looks good.

it turned out really well, I was nervous about the star infill choice. but it printed out wonderful I have no complaints.