jsphillips86

jdlg2065

Print at 100% infill with a layer height of 0.2mm with a base layer of 0.2mm. Also, use a brim to prevent lifting in corners.Filaments Used(Try to use similar colors to match my print): Black - Hatchbox PLA Dark silk blue - Generic PLA Light blue - HatchboxPLA Orange - Hatchbox PLA Yellow - HatchboxPLA White - Hatchbox PLA Filament Swap Instructions: Black until layer #9 at 1.8mm Dark blue until layer #12 at 2.4mm Light blue until layer #13 at 2.6mm Orange until layer #14 at 2.8mm Yellow until layer #16 at 3.2mm White for the rest. Note: If resizing STL, leave STL's z-height the same.

The Starry Night - HueForge

HueForge

ToZiomek

Printed with X1E, filament ASA 3DROSA. The model fits into the scissors by pressing.

HueForge

Replacement Parts