great model 👍 as a mechanical engineer I really like the details of the gears etc. printed without any issues and assembly was well described. I used o rings from the bambulab store which turn out a good decision. also Im currently using sand paper which works quite well. but I'm gonna switch to a diamond disc once the sand paper is worn out. be careful with the magnets! at first I was sceptical wheater they really need to be that brutally strong but with large knifes it's good to have a firm grip by the magnets. if you are not experienced with rare earth magnets take your time and built really carefully. two magnets rushing together can cause serious injury when scattering upon impact.

very good print quality, the supports were a bit of work to remove but nothing that took longer than 5 minutes. Looks brilliant with a led candle light!

beautiful model, really love it. printed without issues

printed in ABS, works perfectly so far even after some very long prints with heated chamber. tube stays in place and the laser module is finally swappable without pulling and remounting the tube every time. thanks!

great model, printed flawlessly. magnets fit perfectly! finally my batteries are nicely sorted and I don't need to start searching in my drawer. the lid is sitting firmly due to the magnets. I really like that because its safer to use :)

printed without any issue. very nice multicolor profile. im really looking forward to assemble it!