Great print. I imagined the slots to be more snug, but the slight play makes it easy to remove the fuses. The lid is necessary otherwise the fuses will fall out. Definitely recommended.

Great print. Holds tight and love the fact that they can be interconnected to create a larger tie.

1 hour print for 4 legs. Excellent. Fit perfectly for the 7mm hole. Printed using PETG

Solid print. I used the profile that didn't use the brim and ironing. I originally didn't want to print this because it used a lot of filament, but after trying others, it was nice to have something that would last longer as it's a tool. Have used it a few times and works as intended.

Excellent print. Used PETG. I printed it normally and the threads came out perfect. The connectors threaded in fine. You have to thread them in so that it's snug and not over tighten it. Also,, if users are finding PETG brittle, redry your filament. I had an issue of PETG reabsorbing moisture while being in the AMS for months. A quick test with loose filament seemed to pass through without much snag. Great job.

This cap fits perfectly! Was about to design something like this but thankfully you had this. Saved me time! Very smooth. Printed in PETG

Great design. Printed in PETG

Works really well. The self holding part is very useful. Great design.

A lot larger than I expected, which is better! Sturdy enough and thinner and more precise than a toothpick

Printed nicely. Used PETG, but found the rear felt a little floppy. Not sure if it was the layer height of 0.24 that contributed to this.