Excellence! Best Dragon Print I’ve done! 👏👏Super cool!!

it was a bit tricky in the beginning. make sure your filament is dry and plate is clean for the start. overall nice print and design. not sure how it will hold up to younger kids but time will tell.

bunny apocalypse! great print!

Great print! got worried about the middle of the spool but worth the thread on concept works perfect!

SO COOL!!! 🙌🙌🙌🙌👏👏

super fun!! great print

perfect print!!!!

Nice looking dragon for younger kids!

fun and they are cute!

Super Fun!! great print!!

super helpful! great print!

super cool! Great Print. dry your PETG before your print!!

looks and fits great!

Excellent!! Thank you..

Cool A… Super Cool Print! Take your time taking off the supports and don’t be in a hurry. The support down the throat is tricky. I cut the bottom and top supports and pulled out through the shoot..

great stocking stuffer. great print!!

great print! had fun! looks great!

Nice! Great stocking stuffer!

I gave 5 on this but a couple of thoughts. some assembly instructions would be nice. I found the video on Reddit. The winding mechanism works pretty well but if you tighten that screw on the top in this pic it doesn’t spin as well.. I loosened it and it works better. it will take some time for the plastic to “wear” and then it will spin better. Don’t over tighten it—It’s plastic.. duh.. overall, fun print!

great print and fun for those Pickle fans in your life! PLA Green and Fire engine red.. white PLA..