Frank M

I3ddruckmarc

This is the Bambu Lab lithophane frame. I cut off the top and added connectors (in Bambu Studio) for a easier print with less support. I also removed the Bambu Lab lettering to lay the top flat on the build plate.Use some glue and put the pieces together.

Bambu Lab lithophane frame - less support

Lithophane

FLAP_Design

Full silica dry pod kit for AMS.&nbsp;Printed with Bambu Lab black PLA matte (see photos).&nbsp;Designed with a hygrometer hole that goes through all the middle pod. that allow an empty reading area for the hygrometer. Data cannot be distorted by silica too close to the reader.&nbsp;Link to the hygrometer used for this dry pod : <a target="_blank" href="https://www.amazon.ca/dp/B07BLY177S?psc=1&ref=ppx_yo2ov_dt_b_product_details" rel="nofollow noopener">https://www.amazon.ca/dp/B07BLY177S?psc=1&ref=ppx_yo2ov_dt_b_product_details</a>&nbsp;***MODEL WITH HYGROMETER SLOT AT 0° (UP/DOWN) NOW AVAILABLE***

AMS Dry Pod Kit + Full Hygrometer Reading Area

3D Printers

85kylestewart

If you're looking for 3/4" elbow PVC connections, you're in the right place! these are designed for elbows on schedule 40 PVC pipe fittings. and make connecting two pieces of pipe a breeze. Just insert the fitting inside the pipe and your good to go with a snug fit, reamended to use PVC adhesive. print settings:walls: 5infil: 10%infill pattern: gyroidsupports: yes- regular&nbsp;

Lithophane

3D Printers

Household