This is an overall nice print, combing axolotls and jack-o-lanterns, but the holes/cavities to put the spikes in for the middle ones on either side are not shaped properly. That, or the spikes themselves should be edited. I had to us a knife and carefully shave off the edge of the spikes a little bit. Then I was able to apply some pressure and made it fit. Otherwise great design.

absolutely one of my favorite prints. the fitment between the different pieces is great, tight enough not to fall apart but not too tight that its impossible to change them around. I printed this with the exact same colors, but now its time to print in different colors.

great print, very quick and fits most people. I, as a glasses wearer, had my glasses instantly fog up with this, so I will see what I can do. but, absolute great idea!

this design turned out great. very fun to print and assemble. both my girls absolutely loved the light.

I used different colors of BambuLab wood PLA. great design, no waste. I did have to use a bit of force to screw in the pegs at first but then they screwed in nice and tight. I barely had time to take a picture, before my wife put her sunglasses on it. very nicely done.

this is a reprint. I already printed a batch and these worked so well I printed more! thanks

great print

great print/model. supports came right off.

quick print, very solid clip.

great design, firm hold on plates but easy to remove at the same time.

fun print, had a few adhesion issues but not related to the design.

only printed one as a trial but great model. very nice design.

I've giving this a 5, even though I have an issue but I believe the issue is on my end and not the actual design. the tolerances are amazing. I made sure that each part had disconnected before really cranking down on the trigger. very smooth operation. now to my issue: the holders are too small for our chop sticks over here. I tried from 4 different restaurants and even used kid size and we can get max 2 inches. our chopsticks locally seem to be thicker than what others are using so if there is a further design, one with bigger holders/grips would be amazing. again my issue is with the chopsticks I have and not this fantastic design. my wife cannot wait to go out.

nice clean print. I added an extra one for rolls that are in storage. Will probably print up a few more of these for all the open rolls I'm not currently using

very nice design, can't wait to put it together, no issues printing.

nice design, tight fit. had some issues with my filament but not related to the design.

fun print, really love how the angles.showcase the different colors of the filament I used.

great build. it was our first time using dual color filament. I lowered the speed of the printing as it was also our first time using Silk type filament.

pretty fun print, great design. I did have an issues with a couple of layers of the base. I will review the footage to see if I can spot anything. I may add some weights to the base to make it a tad bit more stable if it needs.

very smooth print, solid but light build, thank you! Printed in a second color. same great results.