banke

mail.iou

Reverse Blade Collapsing Katana - Rurouni KenshinThis is a telescopic katana inspired by the Japanese comic &#34;Rurouni Kenshin&#34;. The parts are printed first and then assembled. You can choose to print different colors and intensities for different parts. The handle is covered for easy future maintenance and blade replacement. But the disadvantage of this is that the printing time will increase. If you don’t like separate printing and want to try print-in-place, you can refer to my previous telescopic knife work &#34;Reverse Blade Sword mini &#34;: <a target="_blank" href="https://makerworld.com/en/models/114630" rel="nofollow noopener">https://makerworld.com/en/models/114630</a> Notice 1. It is recommended to use PLA+、PETG for printing. 2. If your filament has insufficient strength, please increase the fill overlap to more than 40%. Assembly instructions: 1. Place the blades in order.2. Close the handle cover.3. Insert two pins to secure.<figure class="table"><table><tbody><tr><td><figure class="image"><img src="https://makerworld.bblmw.com/makerworld/draft/816624/2024-04-05_875177ce7d12f.png"></figure></td><td><figure class="image"><img src="https://makerworld.bblmw.com/makerworld/draft/816624/2024-04-05_c7733b9e5bd43.png"></figure></td><td> </td></tr></tbody></table></figure>4. If you need to use the lid function, you need to bring four <a target="_blank" href="https://www.amazon.com/8mm-magnets/s?k=8mm+magnets" rel="nofollow noopener">8x2mm</a> magnets and use glue to fix the magnets in the four holes.<img src="https://makerworld.bblmw.com/makerworld/draft/816624/2024-04-05_3e9c49dc69878.png">&nbsp; Remark: A. If the pin is too loose, you can apply removable glue, such as Styrofoam, to the tip of the latch to facilitate removal during future repairs. B. If it is difficult to align the exit hole when the pin is inserted into the tool holder, you can use a blade to push in the direction of the hole to facilitate alignment of the exit hole. C. If the blade gets stuck while playing, you can try two methods: 1. Hold the top of the blade and the handle, pull the blade up first, and then slide it down to the handle and tap it. Go back and forth several times without using too much force to loosen the stuck blade. 2. You can put a few drops of silicone oil into the joint of the blade to lubricate it, and then use the first method.

Reverse Blade Collapsing Katana - Rurouni Kenshin

玩具

Dan_ID

This is a stand to hold your Apple Watch Charger. Works with all versions of the Watch charger (USB-A and newer USB-C) and all versions so far of the Watch including the Ultra. It may not work with all cases.Putting some rubber feet on the bottom will help with sliding.&nbsp;Printing Tips:<ul><li>Best in Matte PLA</li><li>4 Perimeters with 20% Gyroid Infill</li><li>CHECK YOUR FIT: It is meant to fit the Watch charger with a slight press fit so you may need to scale it up or down depending on your settings and filament. I've scaled the model from the first version posted.</li></ul>

玩具

工具