user_2417006917

Jamburgg

Meet Owen, the cute crochet turtle!! Yet another addition to my crochet animal collection!!&nbsp;If you like my models consider supporting me with a coffee! <a target="_blank" href="https://buymeacoffee.com/jamburgg" rel="nofollow noopener">https://buymeacoffee.com/jamburgg</a>&nbsp;Print Guide:Prints in one piece and can be painted either by hand or in the slicer if you have an AMS. I have included a single colour print profile as well as a painted -multi-colour print profile.&nbsp;Walls/Perimeters: Any. Purely decorative so doesn&#39;t need any strength.Infill: Any. Same as above.Supports: None. The slicer will show several areas as overhangs, however the texture covers up the small imperfections and adds to the crochet look!Layer Height: ≤ 0.1mm  As the model is quite flat, a smaller layer height will give a better finish. Variable layer heights can be used to save print time.Material: Any. PLA used here but any can be used&nbsp;

Owen The Crochet Turtle

potter

CK Designs

This is an updated version of my “Locking Wall Mount For Milwaukee Packout”. I took inspiration from Sean&amp;Lucia&#39;s Packout mount on Printables (https://www.printables.com/model/357256) but completely rebuilt it using my easy alignment method.&nbsp;This new version can fit a plate that holds all 6 feet compared to only 4 before. It also uses less material, no supports, and prints faster (I also think it looks a lot nicer than my last design) I also included a removeable locking tab in case you need to make sure your box won&#39;t fall out of the mount. This mount does hold the boxes fairly snug without the locking tab though as you can see in the last picture where the box is upside down. The mounting holes were designed for regular drywall screw, but you may be able to use other screws as well.&nbsp;Please note that the licensing doesn&#39;t allow for my file or prints of the file to be sold

potter

packouy