I love them, and strangers love them!

closest thing I could find for my alpha-bits cereal ouija project. very happy

printed fine, holds a power bank under the bottom tray so I can charge my phone and devices whenever. I've been so sick of my purse getting all messy so this is perfect to be able to get to my stuff easily. also I printed my bolts and glued them near the head,

nice and sturdy. i like how all the colored pieces print face down so they have a nice surface on the finished project. It fits perfectly over a normal thumbtack to hang on the wall.

The model would work a little better if the hole in the base of the top piece was wider, allowing the tubing to fit through it and the "adapter" piece to sit in the top, and a hole in the side of the bottom to allow the tubing to be routed out sideways instead of downward. I'm using a pump with lower flow, as a higher flow will not fill the tipping part slowly enough. if you're printing with ombre filament, print the top section AFTER the bottom section so you have a seamless color change.

purple is plate 1, blue is plate 2. might be a little too thick for a car magnet, so putting it on my front door instead

super cute so far. my best friend is going to love her Christmas present 💝

infuriating to assemble correctly especially after one piece fails... and you reprint the wrong one... and then have to figure out which one is right to reprint but I got it, then someone took it apart and I had to do it all again, which took 5ever. I'll be printing a cage to keep this in. Or to lock up whoever pulls it apart.

I originally printed the one with open bottoms, but my scallions kept slipping down into the water. so I've reprinted with the closed bottoms and all is good

Changed the colors up a little bit so my daughter can have a little avatar for her advent calendar chalet diorama. I cannot get over how precious she turned out 😭

Can't wait to print this in all kinds of colors, only suggestion I have is possibly offer a plate with the pull tab on its own to save a little filament waste.