The Stoli game prints perfectly! I'm going to create a box for it and then covertly leave it in the break room at work. I expect productivity to take a noticable dip!

The artwork and overall design is excellent. My only issue is with the locating studs used to keep the pieces located on the board. First my print didn't cap the locating studs on the board so they were left a bit short. oddly the rest of the board print worked great. Second the fit is a little too tight with the pieces themselves and the board, This may be a result of the first print issue i mentioned but the studs were high enough that they should have at least sort of engaged with the recesses in the pieces. Third the support structures in the pieces didn't come out with the most grace. I tried a few tricks to improve this but nothing seemed to improve over the original print profile. Instead I would suggest replacing the studs with full pyramids and matching pyramids in the pieces. Doing this would eliminate the supports needed for the pieces , and ensure the pieces actively engaged with the board regardless of tolerances. I Look forward to printing the full collection

An amazing tool. I'm just sorry it took me so long to find it. This is an absolute must have for any 3D printer.

The model and finished product are great! I gave these to coworkers as stocking stuffers and they loved them! However, a combination of factors went into my lower rating. First my product loss rate was roughly 20%. I think there are three factors that played into this issue. 1) I'm using an A1 bed slinger to print these tall thin objects. About the time the machine starts printing the pen tip things are really starting to wobble. 2) Having to add the spinner mid print durring a pause means the pen receives unneceassary handling, which leads to the print becoming detached from the bed. 3) Once added the live load created by the spinner slowly works to detach the print from the plate. Print these one at a time, not in batches! You also need to make sure to print the spinners first! I'm giving the Santa's Hat a better rating than the box simply because it involves fewer parts to add mid print. Print these One At a Time!!

the design works well. it clips into the saw and holds it firm. my only issue is the little tiny screw holes. I'm not sure what size screw this was designed for but it sure wasn't a number 8.

I use this as my backup knife at work on a weekly basis and it works great. Its small and easy to carry, hangs in my locker perfectly, and even looks good. My only nit-pick is that the blade does tend to deploy in my vest pocket. I'm just waiting for the day when it cuts its way out of the pocket or slices my hand. Until then It's a great little knife.

I've printed a half dozen of these and they seem to do a decent job of holding the larger desicants. I've had issues with the smaller more powdery desicants and the clay based desicants but I'm not surprised. I live in the middle of a desert so I'm not sure If moisture is an issue or not.

Fits the threaded 5 gallon jugs great. I've printed several for work because they keep getting lost. its a perfect match.

These shelves are amazing! They hold all the filament you could want and look good in the process. mounting them is super easy with the included guide and a leveling device (I used a laser level). I've got two sets and will absolutly use them again when my filament collection grows.

these work great! I printed up about 30 for friends and Halloween presents. They work great the kids instantly knew how to play with it and the coworkers were properly distracted!

works great. I might have gone for a faster thread pitch but the kids and coworkers loved it. I made a couple dozen to pass out for Halloween

needs a little bit of post process with a knife to rolun smoothly but otherwise fantastic. I made a dozen to pass out for Halloween.

I printed this in PLA silk because it was what I had. I then proceded to use it to dig a 2 cubic foot hole in the ground and then scoop a bag and a half of wet concrete into said hole. The handle broke off about half way through the process. the scoop is fantastic!

fits great!