Handy sanding pad holder. Printed very well.

This project took a lot of time and filament, but was worth it.

Love these small clam shell boxes. They print cleanly and stay closed. Good design.

This was a very good print. I made two of them, one for my Kirkland 13 gallon bags and another one for my large 45 gallon contractor bags used in the garage.

Very good design and print. This fit my CMT kit perfectly.

Nice holder. The print was very good. The only problem I has was with the hole in the corner for the hex key. The hole is too small for my key.

All I can say is THANK YOU!!! This is the first stacked print that I have found to actually work. All others either warped or were impossible to take apart. This one worked flawlessly several times. You just have to make sure to follow the directions precisely. If you are unsure about something in the directions, then ask someone.

I printed two of these stands. The first one was printed using the suggested profile. The print was a success, but I felt that the legs were too loose and tended to screw in by themselves while using the stand. So the second print I used the standard 0.20mm profile. This time the print failed at around 75% completion. I used it anyways, as it was just a bit shorter. The leveling legs thread in tighter and do not adjust on their own.

I have printed at least 50 of these spools, I started using PLA, then switched to PETG, and finally to ABS because the lesser materials were deforming in my dryer. I have never has a print fail and the parts always fit together perfectly.

I haven't actually used the guide yet, but it is much better than the $27 one from Festool. This printed with a raft which was difficult to remove.

Awesome addition to the shelf bracket. Made installation of the shelf a breeze.

I printed eight of these brackets for filament storage. They were printed in my X1C with Sunlu ABS. After the first six had some warping issues, I finally decided to add some painted on Brims and that solved the issue. I especially liked the screw template that was supplied with the bracket model. This template made installation a breeze.

I have printed several of these organizers for my kitchen. They all printed very well with PLA on the X1C and the A1.

I have printed tons of these Gridfinity bins in PLA and PETG. I like the thicker side walls and basic bottoms. I have had troubles on my X1C printer with warping. I finally realized that turning off the Aux fan eliminated the issue.

The part printed great. I used PETG and had no issues. The only problem I have is with the design. The pliers don't work very well to open the pistachio.