Teo023

DisgoPrint

NOT MADE FOR TPU.&nbsp;I made an iPhone 12 Pro Max case that supports magsafe charging. I tried printing other cases, but determined that they all were too thick for my liking. I therefore made a case that was only 1 mm thick.&nbsp;I print the case in two parts and then glue the camera bump on to be able to print without support.&nbsp;Printed in black PLA. 0.12 layer height, 100% infill, 0.6 nozzle.

iPhone 12 Pro Max Case

Elliott_

Made these TPU feet to help dampen my Ikea lack table, also made some shims to help get rid of table wobble.

teo

Endcloser