Magnets were a little tight getting in but worked perfectly for what I wanted.

Only a small row on the top left didn’t turn out but the rest looked good. I think it was more the printer issue than the design. I would make it a little bigger to the size of the full plate next time if I was going to print it again.

Details were amazing but the tail didn’t turn out. I was able to clip off the little part at the end that didn’t turn out.

Printed very well and looks exactly like my lab.

It’s three pieces that kids connect to Lego’s. My daughter wanted it and I printed it for her. It came out looking good and she was able to connect to her legos without a problem.

looks good my bird is a little afraid of it though, printed perfectly.

works well and looks good

Good size and printed well.

They printed fine, there just really small so it didn’t work out for what I needed it for.

Looks good when it’s done but some of the plates like the tie plate were difficult to print and had to reprint a few times in black PLA because the silk PLA print wouldn’t turn out. The bad prints were stringy or would pop off the plate.

Worked great used it for my daughters valentines box for school.

Looks good but needs a backing option due to all the pieces.

The support underneath makes it hard to get the bottom smooth and the tires didn’t work out as well. The top looks good.

The first lid the printer had troubles with. Printed it a second and it worked great with base storage container snapped on without problems.

It’s a little thin but looks good.

Looks really good a little fragile on the ears, had to reprint the ear because broke when putting it on but really like how it turned out

Printed well and works well. The supports came off clean.

Worked great, printed three so everyone in the family has one. Worked best with the Bambu Matte filament of black and silver. The one in the picture was a little weak in the rounded end. I think it’s because of the filament strength.