printed with no issues.

looks absolutely beautiful. this is by far an underrated print.

the back legs had a little bit of spaghetti and easily break off.

looked beautiful until prime tower fell over and the head didn’t fully print. not sure if there was a setting I was supposed to turn on the fix this but I would definitely check the instructions for one because I could not get it to print correctly with the default settings.

the last ring is a little tight to turn.

printed out a whole bunch. you can throw them insanely far!

the front of the helmet can bend a little so be gentle with it. looks great tho!

looks great although the sides are very thick so it doesn’t hold much.

works well even if you scale the size down.

looks cool but there are so many supports in the bottom is isn’t verry smooth and hurts the esthetic effect a little. migh help is you use support filament.

printed perfectly

looks perfects. supports are pretty hard to remove. would recommend using a razer.

absolutely beautiful and doesn’t even need supports.

looks sleek and a fast print.

beautiful and they screw togeather perfectly. one of the best designed I’ve ever printed.

looks great although some of the legs printed stuck together and I had to use a knife to cut them so that they would move.

the hinge works amazingly well. I did print that at original scale and it turned out quite large. might want to scale it a little smaller since it doesn’t really fit in your pocket at full size.

works great. you have to wiggle it a little at first to get it moving properly.

fantastic. super detailed

worked as expected