user_2269311840

vhart0

My wife bought some new thread spools which don't fit on the holders I printed for the rest of her spools, so I made this design in Fusion 360 to hold four spools with a wider diameter.<a target="_blank" href="https://ko-fi.com/vhart" rel="nofollow noopener">ko-fi.com/vhart</a>

Skadis Spool Holder 43mm (for e.g. Embroidery Spools)

House Hold Items

Nufajs

3 various models for ½, 3/8 and ¼ socket sets. Simple and tilted - sockets are at Your disposal immediatelly.You need 2 universal hooks for each holder. Hooks are attached as STLs as well.Enjoy and check my other holders for Skadis board

IKEA Skadis holders for socket sets 1/2 3/8 1/4

IKEA

franksj

I increased the length and width of the holder for strength. The filet for the corner has been increased to prevent the stock wiper from hitting it. The orientation has been changed as well for strength which does not require supports. The open corner has been trimmed so it does not interfere with the build plate which occurred with the original on my P1S.&nbsp;Requires a 5mm Brass Wire Brush with a 3mm (1/8&#34;) shaft. Example: https://www.amazon.com/dp/B0CR3ZBWTF&nbsp;Be sure to insert the brush completely to avoid it being too high and possibly colliding with the nozzle.&nbsp;I recommend printing in ASA or ABS.

House Hold Items

IKEA

P1S Upgrades