One star deducted because screws do not stay tight.

The box in this design is well done EXCEPT for the fact the the writing is facing the wrong way. If you are looking at the box with the hinges at the back (like getting ready to open it), the writing should be readable but it is backwards from this orientation. It is still a nice box but could have been even better.

Beautiful print!

This is a beautiful design. I deducted one star because the leaf stems are way too fragile and one leaf broke off even though I carefully/slowly removed the supports. I managed to super glue it back on but a thicker stem would have held up better during support removal.

Good, easy print. I added my own lettering for a custom look.

This is a nice print overall but I deducted one star because the hinge design is way too tight. As other reviewers have said, I had to use a rubber hammer and beat the top and bottom into place.

I made this for my Yaesu 991A. The screw holes in my radio do not line up with the openings of the side panels so I made a flat, rectangular cross piece to link the two sides together. Worked great!

Very pretty flower BUT way to fragile center parts with tons of supports stuck to them. Deducted 1 star because of this.

Great print

Great print! I ran it in PETG and it came out really good.

Nice print! I made it in PLA-CF - now it's super strong....LOL

Nice print! I scaled it up a bit and printed in PLA-CF. Works great!

Works great. Easy print!

Worked like a charm in my AMS 1 and X1C

Very nice design! I printed in PLA+ 2.0. Interlocks fit great. I also printed the base in this listing.

Very nice print. I used PLA Marble with PLA Basic in Brown and Black.

Beautiful print. very detailed and artistic. I scaled it up a bit and printed in PLA Silk Silver color.

I printed in PETG on X1C with smooth PEI plate (cleaned and then sprayed with 3DLAC). Printed great - adhered to plate well and released easily. No brim needed.

Printed in PETG. X1C on PEI Textured build plate. First attempt failed. Needed a brim. Came out great when using a brim. Designer mentions this in his description - so five stars on my rating!

Very nice, detailed print. I am subtracting 1 star only because the small "pimples" of material it uses to secure several areas for improved hinge printing are very difficult to remove without marring the surface of the box. Now that I have printed it and had to deal with the small dots of extra material, I would have preferred a box that was assembled from separate parts so those extra material dots were not there.