exactly what I needed. fits great and now functions like before. thanks for uploading this

overall decent print. the part that fits onto the print bed doesn’t make sense to me, no screw holes available?? kept that bit off and just attached the chain using the back clips which seems to be holding it in place. 15-20hrs of printing later no problems

printed well and works great. bottom part doesn’t seem to fit new gen A1’s as there is a bulge in the cable. I’m sure I could have made it fit but would likely damage cable. left the bottom bit off and still works and looks great!

came out great and fits perfectly!

First print I did on my new a1 (other than bench of course). came out great and works well. the scraper holder does a good job however the piece that connects to the z axis is slightly small so gets a bit loose after a couple of times taking out the scraper and putting it back in. still works but have to push it back in every now and again.