Nice prints. Fit well with the dry box .

These are perfect! I was getting tired of threading filament through the holes in the real every time I wanted to use the dryer - would end up snipping off 3-4 inches every time to remove the kink. This solves that problem full stop. Nice work OP 👍.

Great print! Finally get to stop picking up little filament coils off the floor. I'm a bit limited on my space, so I scaled the X axis to make the bin 5.5 CM instead of 7.5 CM. Kept the dimensions of the cutout for the chute and the height the same. This sacrificed a couple of wall layers on the Y axis but it still came out plenty sturdy. I also found that if I moved the prime tower closer to the model was able to shave a couple minutes of the print time.

Great tool box to keep all those included H2D tools and accessories together. Really liked the print-in-place design - no additional hardware needed 👍. I used PolyLite ASA.

Perfect, simple little clips. Took no time to print at all. Does a great job holding unused filiment in place without kinking the filiment. I used PolyTerra PLA in Savana Yellow. Nice work, OP 👍.

Great print profile. I used ABS-GF. First-time using this material and I have to say its probably my favorite so far. it has this texture that seems to blend naturally with the layers so you can hardly tell it was even printed. Looks closer to injection molding. Great work, OP, keep them coming.

Outstanding print 👍

very first test print with the H2D. came out flawlessly.