They work but are stiff

Cool model but shows layer lines clearly on the roof, could rotate the model a little and print with supports to minimize this.

it works but printing in pla basic it can be a little too stiff while also not clamping anything thin very well.

One of the first things you should print, and this one works great and uses little material compared to other designs. If you are using the external filament spool on the back it will hit the arm of the chute, but this can be solved by cutting part of the arm off in the slicer or with scissors.

it works as intended

Great print and can print without supports, but some support under the nose can help.

Great tool and works well, useful for estimating how much filament you have before a long print.

Works very well but make sure you have a usb c to usb c cable and in the exact right length.

Great print and turns out very well, glue usually needed for the pupils and the three pieces in the stomach but other than that it is press fit.

Amazing model but removing supports from the suspension arms can be a nightmare with pla basic, I would recommend changing the top z distance for the supports to at least 0.2 or 0.25 to make removal easier.

Works perfectly and is a good alternative to buying a spool.

works well and helps prevent crossing over on the spool