user_1745887648

Scubafan

<p>Over the years I collected quite a few Apple Watch Bands but I couldn't find a good solution to store my Bands in a good way. So I came up with my own design wich is based on the Rugged Box</p><h3><strong>Printing & Assembling</strong></h3><p>I would recommend printing at a 0.2mm layer height. 2 latches are needed. Printing the TPU seal isn't needed unless you want to water tighten the case. The latches and hinges are made to fit M3x20.</p><p>The Insert sits very tight in the bottom part of the box, no glue is needed.</p><h3><strong>The Slots</strong></h3><p>There are 3 different sizes of Slots</p><p>S fits the Solo Loop and Silicon Solo Loop</p><p>M fits the Sport Loop, Trail Loop, Alpine Loop, Milanese Loop and thin Leather Bands</p><p>L fits the Ocean Band and thinker leather bands</p><h3><strong>Inserts</strong></h3><p>There are different inserts with different slot sizes. Pick the one you need. More variations will come in the future.</p>

Skal printes