Michael Wirtz

mlodybuk

(A1 VERSION IN MY OTHER MODELS)During this upgrade, some parts of your printer may be damaged, I am not responsible for any damage caused by incorrect installation or other damage. If your cables appears too short for this mod you should not install it.This model allows A1 MINI users to adjust camera angle! I remixed well prepared @henlor A1 Mini faceplate model (by adding a mounting hole) with my A1 camera holder&nbsp;INSTRUCTION (It&#39;s prepared for A1 version but will work the same with Mini version): Print all 3 models as they are in print profile, camera holder should be printed with supports DURING NEXT OPERATIONS THE PRINTER SHOULD BE TURNED OFF! <a target="_blank" href="https://wiki.bambulab.com/en/a1-mini/camera-replacement-guide" rel="nofollow noopener">Remove original faceplace and camera according to BambuLab instruction</a> Push camera into it&#39;s new holder, it&#39;s supposed to be pretty tight so vibrations won&#39;t make any noise<img class="image_resized" style="width: 284.109px" src="https://makerworld.bblmw.com/makerworld/model/DSM00000000476062/design/2024-05-26_a421953c70d76.png"> Put new faceplate on the X-axis with the cable going through a hole and carefully bend the connector 90 degrees, it&#39;ll be easier to connect it.<figure class="image"><img src="https://makerworld.bblmw.com/makerworld/model/DSM00000000476062/design/2024-05-26_5b47781f95f6e.png"></figure>Push the cable through camera holder hole and connect it.<figure class="image"><img src="https://makerworld.bblmw.com/makerworld/model/DSM00000000476062/design/2024-05-26_6ca89baf6ea96.png"></figure>Push in the camera facing down and rotate it so it locks<figure class="image image_resized" style="width: 221.188px"><img src="https://makerworld.bblmw.com/makerworld/model/DSM00000000476062/design/2024-05-26_0b6d72aa1e2e6.png"></figure><figure class="image image_resized" style="width: 215.5px"><img src="https://makerworld.bblmw.com/makerworld/model/DSM00000000476062/design/2024-05-26_4d5b7eaf58244.png"></figure>Put the back cover and adjust the angle<figure class="image"><img src="https://makerworld.bblmw.com/makerworld/model/DSM00000000476062/design/2024-05-26_caaebee990e58.png"></figure><figure class="image"><img src="https://makerworld.bblmw.com/makerworld/model/DSM00000000476062/design/2024-05-26_e28e8825bf046.gif"></figure>

Bambu A1 MINI Adjustable Camera Holder

a1mini

calebtimoteo

Any feedback would be greatly appreciated.Could be use as a planter, pen holder, etc&nbsp;Nozzle:0.4-0.8mmLayer:0.24-0.4 (Recommended)&nbsp;No supports needed&nbsp;pacman remix could work better: <a href="https://www.printables.com/model/544285-pacman-remix-with-thicker-mouth-roof" rel="nofollow">https://www.printables.com/model/544285-pacman-remix-with-thicker-mouth-roof</a>&nbsp;Scale it as you like :)

a1mini

Stuff