沙丘十一哥

Olivia

We designed these desk shelf legs generatively in Fusion 360 and produced them with SLS using the Sintratec S3 printer and robust PA12 nylon material. After printing and cleaning, we simply screwed the legs onto a wooden board and voilà: DIY Tabletop.

Table Legs for a Desk Shelf (Generative Design)

有意思

QingHuan

这是一个国潮小狮子寓意招财进宝，你可以使用丝绸耗材或者大理石耗材进行打印会带给你不一样的感受。This is a national tide lion meaning fortune and treasure, you can use silk filaments or marble filaments to print, will bring you a different feeling.

可爱小狮子 招财进宝  The little lion cute

好玩

axtrinocreations

Update III 11-19-22: Added a remaining filament measurement marks. These .2kg marks match the positions that Bambu Lab has on their spools. Even so, these are estimates at best.Added to the following STLs: Bambu Lab Reusable Spool Remix Four-Short-V6.stl Bambu Lab Reusable Spool Remix Four-Tall-V6.stl Bambu Lab Reusable Spool Hex Snowflake Tall - label v2.st Do not use ‘adaptive layer height’ as that will flatten these marks and numbers out. UPDATE II 10-24-22: Corrected Tall Snowflake side to have proper pattern alignment with short side (cosmetic correction). Provided two versions of the Tall Snowflake half. One with label space, one without. UPDATE II 9-30-22: Added lightweight ‘Snowflake’ version of the Spool! UPDATE 9-30-22: Corrected missing alignment tab on tall half of the spool. Cleaned up other minor imperfections on both halves. Set the spool diameter to 200mm to match that of the Bambu Lab versions. Added the bambulab_spool_spacing_shim.stl (print two). Current is V5. UPDATE 9-27-22: Based upon feedback I have decreased the diameter of the center spindles to match those of other Bambu Lab reusable spools. UPDATE 9-14-22: I have repaired the short side to be a more manageable size (was 9MB).I have combined the best features (in my opinion) of the three previous remixes.I started with the refactored “Bambu X1 Re-Usable Spool” as a base, then added the best features of the “Improved Bambu Lab Reusable Spool Holder” (everything except the heavier hex pattern), both of which were remixed from “Bambu Lab Reusable Spool Holder Hex Remix”.I added an additional label space on the other spool half. I like to have both sides labeled, (trust me it saves time). I also tilted the 6 pairs of holes all around the rim at 45deg to make it easier to secure the loose filament end (and not crimp it so you end up trimming it off later).

有意思

好玩

打印机相关