very cool print. I added some thickness to mine to make it less fragile. made mine 2.4mm thick. then added some white stripes to the lighthouse and the sail of the boat. love it.

Perfect fidget! No hangups or sticky pieces!

tons of fun for the zombie lover. use a sharp xacto in the back to get the eye movers loose.

Great fidget! one of the few that comes off my printer and works perfectly from the 1st push. No hangups or tolerance issues.

One of my fave prints so far! have made at least 10 for friends and family,

cool print! perfect as is in PLA and using filament as the hinge.

made mine out of red/black shift PLA silk for a killer "bloody" effect. awesome print!

this is really big. i decreased the size to about 50% for it to look "cuter" on a door top.

Love these as gifts to friends who like me work in the defense industry. Only change i made was to increase the thickness of them to 2mm. made them a bit stronger in PLA.

Love these as gifts to friendS who like me work in the defense industry. Only change i made was to increase the thickness of them to 2mm. made them a bit stronger in PLA.

super nice, i sliced off the mag well portion and then the vertical ears off the stand then reduced the stand top width to fit "inside" the picatinny cuts on the K-19 toy Glock. Then i added a Glock "logo" on the stand. Now it is a great display piece.

tons of fun and addictive. can substitute airsoft BB's for the metal ball bearings in case you have those laying around.

For mine i increased the width about 25% and then sliced off the bottom about 10 layers to make the stability of this a lot better. otherwise i thought it was too easy to tip over. love it for kids!

one of the better of these types of fidgets. Stick are a little long. But prints great in PLA and easy to change the colors for the different rings.

One of the best and smoothest fidgets i've seen/made! Printed in color changing filament and it worked flawlessly. Def a must print for any fidget fan!

was a bit tight and hard to separate the rings after printing in PLA. Was afraid i was going to break it. But then it was fine.

the small clips are great - just know you will have to separate/pry the tail from the print and the jaws to open. Once you do that it works great!

This is my favorite knife model of all. Have printed 2 dozen of these. Works great in PLA and PETG. Integrated twine cutter and possible keychain holes are killer features. A must print to give out as gifts.