Hello everyone, I hope you’re doing well. I am looking for help with a custom 3D print project and was wondering if anyone could assist me or point me in the right direction. I need a 3D printable case designed specifically for the Pulsar APS3 battery with the following specifications: Battery type: Lithium-ion (Li-ion) Voltage: 3.7 V Capacity: 3200 mAh Approximate size similar to an 18650 cell (I can provide exact measurements if needed) The case should securely hold the battery, allow access to the terminals, and ideally be made with safety in mind (ventilation, insulation, etc.). If anyone has an existing file or could help create a custom design, I would be very grateful. I am happy to provide any additional details or measurements needed. Thank you very much for your time and help! Best regards,