turbolarsen

Squish3D

Do NOT adjust the thickness (Z) in your slicer!! The layers will not come out right. You CAN adjust the other dimensions (X,Y) though to make it bigger or smaller, just not the thickness.&nbsp;These were my settings and colors for my print that you see in the picture. Your results may vary depending on the filament you use and if you have your own HueForge profile saved with different settings.&nbsp;Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm&nbsp;Nozzle: 0.4&nbsp;Filaments Used: PLA Sunlu Black Transmission Distance: 0.6 PLA BambuLab Basic Blue Gray Transmission Distance: 3 PLA PolyLite Aqua Blue Transmission Distance: 2.5 PLA Sunlu White Transmission Distance: 5&nbsp;Swap Instructions: Start with Black At layer #25 (2.08mm) swap to Blue Gray At layer #27 (2.24mm) swap to Aqua Blue At layer #28 (2.32mm) swap to White for the rest

SpiderMan Kneeling - HueForge

hueforge

fay3dlab

I'm back with another suspended model Star Wars collection.. this time its the Imperial shuttle that Darth vader and Emperor Palpatine uses..&nbsp;The model was remix from aaskedall again from thingerverse.. he really has great star wars 3d models.. I remixed the shuttle using Tinkercad.. i had to redesign the middle fin of the shuttle so it can be printed without supports.. modified some parts too so it can be printed without supports.. For the frame for the shuttle to be suspended.. i designed it to look like emperor palpatine's throne.. The model is also small enough to be printed on the A1 mini but you wont have room if you want to print multicolor..The whole model is just in one part.. i also made the model to be multicolor print.. i separated the shuttle.. strings.. and the frame.. so you can pick your own color for each part..&nbsp;One important thing to remember when printing suspended models is to set the wall generator to arachne from classic.. this will make the slicer print the strings.. I hope you guys have fun printing this suspended&nbsp;&nbsp;