605ZZ BALLBEARING WEIGHT INSERT FOR FLASHFORGE/CLAS OHLSON FILAMENT SPOOLS

Filament Dust filter that does not break easily.

Custom Axle Lock for Miklos filament spooler

New REMIX from Toffypops - Parts for Miklos filament spooler winder.

Updated my adapter with both Miklos and Pastamatic support.

This lock i made has a custom made rightside for the target spooler, and the lock also fits the Source spoolers on both sides of the pastamatic.

I found that the locked side on the target of the pastamatic was cumbersome to get spools into without having to assemble everything after it was inserted. I therefore designed a locking mechanism, based on the original leftside cogwheel locking clip , but supporting a 608 ballbearing for the righthand side so it would be easy to remove and lock in place the target-spooler of the pastamatic after it had been secured to the spools. I added 608 ballbearing since the roller may jump during use.

Miklos Kiszely's remix target rod for pastamatic. I prefer the target and source rods for the Miklos Kiszely's spool winder, and have made Pastamatic adaptations of this so i can use the same adapters for the pastamatic as I used for the Miklos Kiszely's filament spool winder. Highly recommend to print with the pre-made settings in the 3MF files included for Bambu Studio as well as Orca Slicer.

I found that the original Source rod for the spooler on the Pastamatic Spooler Winder was too Wobbly. I like the Miklos Kiszely spooler winder's source rod, so i adapted it to fit the Pastamatic. Also include a small adapter for smaller spools. The rod model has a hole through it where you can insert a 6mm metal rod. It takes a bit of gentle hammering, but it will fit. It helps stiffening the PLA so it does not break.