toaster

BDPStudioDesigns

A custom made token holder for 25mm tokens. There are a total of 10 slots to hold a variety of tokens. The lid and holder both have holes for 2x10mm magnets. The lid also has some very short extruded areas that will slot into the four corner openings of the holder. These extrusions prevent the lid from easily sliding off if bumped. The photos are of the original design, which proved to be a little weak in the middle, so it was revised for strength.

25mm Token Holder With Lid v2

OurAngryBadger

Wall Switch / Outlet Cover (Slim)Simply a thin and slim wall switch / outlet cover for the rectangular type switches and outlets such as the Lutron® ones.

Wall Switch / Outlet Cover (Slim)

Practical Prints

printingsolutions.info

My remix xtouch enclosure for Bambu Lab P1P &P1S includes an optimized micro SD Card slot and pen holder. A simple enclosure for the xtouch P1P/S interface by xperiments: <a target="_blank" href="https://github.com/xperiments-in/xtouch" rel="nofollow noopener">https://github.com/xperiments-in/xtouch</a>This version houses the ESP32 touch screen in a way that replaces the standard printer controls, but swivels up out of the way to reveal them when needed. You get the appearance of a single touch screen, without losing access to the original control panel.&nbsp;Hardware:The required ESP32 touch screen is linked on the xtouch GitHub readme.A USB-A to USB-B micro cable approxmately 200mm in length is ideal. 6 x M3 x 12mm countersunk bolts for attaching the rear to the front pieces.2 x M3 x 12mm bolts for attaching the enclosure to the adaptor.1x 2.8-inch ESP32-2432S028R board (<a target="_blank" href="https://s.click.aliexpress.com/e/_DmcFFVz" rel="nofollow noopener">ESP32-2432S028R</a> or <a target="_blank" href="https://s.click.aliexpress.com/e/_EwiGjNZ" rel="nofollow noopener">ESP32-2432S028R</a>)1x micro sd Card&nbsp;Further informations:<a target="_blank" href="https://github.com/xperiments-in/xtouch" rel="nofollow noopener">https://github.com/xperiments-in/xtouch</a>&nbsp;Easy LED Riser fits for P1P and P1S and supports cable management for xtouch display and LED mounting:<a target="_blank" href="https://makerworld.com/de/models/45124#profileId-46838" rel="nofollow noopener">https://makerworld.com/de/models/45124#profileId-46838</a>

TTG

Practical Prints

xtouch