tlisek

Cholas

Simple holder for iron tip cleaner for multiboard. Remixed from the HSW version https://www.printables.com/model/603002

Soldering iron tip cleaner for Multiboard

Workstation

RevelRob

I Just built the Marble Run 003 Components Kit from Bambu Lab and was excited for my toddler and pre-schooler to play with it. Although they loved watching it go, they really wanted to control the elevator. So I decided to look for a manual hand crank to print for it and found this great design by Pretzel 3d (https://makerworld.com/en/models/50487#profileId-52241). Unfortunately, I was faced with some problems: the ones I found required removal of the motor, or were a weird fit; and my kids would get confused and sometimes send the elevator backwards which would jam some marbles underneath the elevator. So I decided to design a one way clutch type model which can work without removing the motor, can&#39;t go backwards, and is just fun to play around with. This all could not be done without the help of some models listed as being remixed from. I hope you enjoy!

Hand 1-Way Crank Marble Run 003 - No Motor Removal

Marble Run

enricoRE

Hogwarts castle Harry Potter HueForge&nbsp;Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm&nbsp;Swap Instructions: Start with Black At layer #8 (0.72mm) swap to Dark Blue At layer #9 (0.8mm) swap to Orange At layer #17 (1.44mm) swap to Yellow for the rest.

Harry Potter Hogwarts castle HueForge

Hueforge

A multiboard mount for Makita Multi-Tool. Attaches using a snap.&nbsp;Based on <a target="_blank" href="https://www.printables.com/pl/model/836770-makita-oscillating-multi-tool-mount-for-wall-contr" rel="nofollow noopener">Makita Oscillating Multi-Tool mount for Wall Control</a>

Multiboard Makita Oscillating Multi-Tool Mount

Mine

Bropunzel

An Multiboard charger holder for an Makita DC18RC S charger.

Makita DC18RC S charger holder for Multiboard

Multiboard

remi.rafael

<div><h1>Summary</h1><div>Those designs are different types of nozzles and a cork for seal guns. You can chose nozzle sizes between 2 and 5 mm. I like the 2mm for delicate works. All models can be printed without support and need no post treatment. For a smooth result use 0.4 layer thickness. The walls are designed to be to layers thick.Edit: After being asked in comment i added 2 models with 1mm holes: "1mm.STL" and "1mm_thin_walls.STL". The first one uses the exact same design with 0.8mm walls but it seemed like a precise work requiring 1mm holes would be wasted by 1.6mm of plastic. So the second model "thin walls" uses 0.4 mm walls. High pressure might break it so bee cautious and don't hesitate to give feedback on those models.</div></div>

Workstation

Marble Run

Hueforge

Mine

Multiboard

To print