timschuette5

yuvalaj

<ul><li>Use high infill and 4 parameters minimum, i printed with 70% infill and 4 parameters.</li><li>Feel free to ask for any iteration, measurements etc.</li><li>share your results :)</li></ul>&nbsp;check out my other models :) towel hanger and more  https://makerworld.com/en/models/389918

Rugged wall hook for heavy bags

useful stuff

casvg5

Just a simple toy. It is a spinning drone or RC dropped dummy bomb. Dropped from an adequate height it will spin stabilize and whistle INCREDIBLY loudly. Don't get yourself in trouble and drop in a SAFE place. I fill the nose up with lead shotgun shot to make it front heavy and fall faster due to a better drag coefficient. I hold the shot in place with hot glue. Be safe and have fun! Find a video with audio on my instagram page @curtburtcurt

LOUD Whistling Bomb Toy

Drone 

JamesThePrinter

Hygrometer stand for easy viewing of your humidity level inside your AMS.&nbsp;&nbsp;<h4>Print Settings</h4>No special setting are needed&nbsp;&nbsp;<a target="_blank" href="https://www.buymeacoffee.com/JamesThePrinter" rel="nofollow noopener">Buy Me A Coffee</a>&nbsp;&nbsp;The following filaments were used in the pictures above:<ul><li>Bambu Lab Matte Ash Grey PLA</li><li>Bambu Lab Basic Bambu Green PLA</li></ul>

AMS Hygrometer Stand

Printer parts

eebee

<h4>* WARNING *: this file is quite large because the model has a lot of small details and if you download be prepared for lag and long slicing times.</h4>Please consider giving this model a boost, it helps me make more models! :)<h2>Snake ring!</h2>this is a ring that represents a snake that bites its own tail. As this model is very small it needs a lot of detail. that is why this should be printed with a 0.2mm nozzle. with the 0.4mm the resolution is not very high. Sometimes the bottom of the ring does not turn out that good so i recommend slowing the printing speed down. This was modeld in nomad sculpt.&nbsp;Be carful when removing supports so as not to damage the ring.&nbsp;<h4>Happy printing!</h4><h4> </h4>

Snake Ring 

For the kids

Techro3D

Classic birdhouse with mounting bracket | By Techro3D&nbsp;<ul><li>Water drainage.</li><li>Fresh air through ventilation ducts.</li><li>Mounting bracket.</li><li>Opening of Ø32mm.</li><li>Removable roof.</li><li>100% printable.</li></ul><figure class="image image_resized" style="width:60.93%;"><img src="https://makerworld.bblmw.com/makerworld/model/DSM00000000407928/design/2024-04-09_6a29650f5618c.jpg"></figure><figure class="image image_resized" style="width:60.01%;"><img src="https://makerworld.bblmw.com/makerworld/model/DSM00000000407928/design/2024-04-09_cf73c20c87ac1.jpg"></figure><figure class="image image_resized" style="width:60.91%;"><img src="https://makerworld.bblmw.com/makerworld/model/DSM00000000407928/design/2024-04-09_8cdb24e6dfe61.jpg"></figure>

useful stuff

Drone

Printer parts

For the kids

Birdhouses