I liked this model quite a bit. It fit my needs quite well. It printed quickly and easily. Thank you! X-1 Carbon HF E3D hotend and Obxidian 0.40, 0.20 layers SuperTack plate (sometimes simply too much adhesion, but perfect here) Elegoo Gray PLA+ Amolen Red (Fire) Silk PLA I made two simple changes in the slicer: The text was too small and its font-face too narrow to print well. Printing text is a challenge with FFDM. So, I upped the text size and used a blockier font face (Verdana maybe?). The lid fit perfectly. It slid open and closed with nary any effort, even a slight till was sufficient. Given the sharp contents I added a small bump to the container (see attached image near right edge) along with a correspond divot on the underside of the lid. The lids still slides smoothly, but snaps into its fully-closed position.

Wonderfully nice bowls. Print very reliably. Printed with: Hatchbox PLA - Blue Denim Priline Wood PLA Default settings except for variable layer height and Arachne wall generation. X1-Carbon, Obxidian HF 0.40

Very nice. Prints easily and well. Easy to load and easy to uses. Printed with: Elegoo Rapid PETG+ Space Gray Prusament PLA Galaxy Black